Wednesday, April 7, 2010

Room Area and Curtain Walls

Let’s take a look at a little known fact about computed room area when curtain walls are used. Below is a rectangular room with 4 basic walls. The Interior Fill subcategory under the Rooms category was checked to make the room area visible in a light cyan tint. In this case the area is calculated at the wall finish.

Fig1

However Curtain Walls don’t have a “finish”; they just have a location line. So when using curtain walls that go all the way to the floor, area is computed up to the location line.

Fig2

What does this mean? If you’re not aware of this fact, there’s a good chance your room area is overestimated. Personally I think putting the location line at the exterior (you have to specify mullion and panel offsets to move the location line to the desired location) makes a lot of sense from a modeling standpoint as you usually know the exterior line of your building. However that is the worst thing you can do for room area calculations, especially with thick curtain walls. So your options are:

  1. Make the curtain wall Non-Room Bounding and draw in room separation lines where you need them (in the above example you would sketch them on the inside face). Now you can place your location line wherever you want.
  2. Set your location line to the interior face of the curtain wall and leave it as Room Bounding.

My personal preference is #2 because most users forget and won’t bother sketching in room separation lines. Do I like how this particular aspect of curtain walls works? Nope, but I’ll deal with it!

Fig3


Share/Save/Bookmark

6 comments:

Arno de Lange said...

nice solusion, but when u use curtain walls for indoor walls, your bound to option 1

Dave Baldacchino said...

You are absolutely correct. Bummer eh? :)

Unknown said...

Hi Dave,
I actually cannot select the location line for curtain walls but just for walls...where do I set it up?

Dave Baldacchino said...

You cannot change the location line in a similar fashion to walls...at least not in the same direct way. You sort of do it backwards...you specify negative or positive offsets for the mullion and panel families instead.

Unknown said...

After six years the problem remains?
I want use a prefabricated system for interior walls and I can not use courtain walls.
Thanks

Dave Baldacchino said...

Nothing has changed.

Post a Comment